Wakol MS 550 Polymer PVC and Rubber Glue content 7,5kg

Wakol MS 550 Polymer PVC and Rubber Glue content 7,5kg For the installation of homogeneous and dehydrogenated PVC floor covering on rolls and tiles, PVC design flooring, CV flooring and rubber floor covering on rolls and tiles, needle felt floor cove...
Article number:
13428
Availability:
Out of stock
Delivery time:
Out of stock (just contact us)

€160,00 €129,95

Incl. tax
excl.btw: €107,40

Wakol MS 550 Polymer PVC and Rubber Glue content 7,5kg,

WAKOL MS 550 PVC and rubber adhesive - first MS adhesive for PVC floor coverings

Modern reaction adhesive for elastic floor coverings

With WAKOL MS 550 PVC and rubber glue it is possible for the first time to safely carry out demanding placements that had to be carried out with 2-component PU glue with a modern one-component MS glue.

Very wide application spectrum

WAKOL MS 550 PVC and rubber adhesive is suitable for bonding all PVC floor coverings as well as PVC designer floor coverings in rubber floor coverings. It does not matter whether you want to place on absorbent or non-absorbent surfaces, inside or outside the floor covering.

For the highest demands on the installed surface

Zones with high moisture values, such as access zones or areas with increased heat loads due to sunlight, such as winter gardens, can be reliably placed with WAKOL MS 550 PVC and rubber adhesive. Challenges such as surfaces with forklift traffic and heavy loads are made by safe and solid bonding.

Immediately start and use surface quickly

Without cumbersome mixing, WAKOL MS 550 PVC and rubber adhesive is applied directly from the bucket onto the prepared substrate. The possibility of using the adhesive on non-absorbent substrates can also be treated directly with eg WAKOL PU 280 Polyurethane primer or WAKOL MS 325 Silane primer pre-coated or sealed surfaces.

Processing comfort and safe application

WAKOL MS 550 PVC and rubber adhesive is distinguished by a very low compression tendency. In the inevitable work on the floor covering, such as when placing floor covering on a roll, knee prints in the surface are minimized. Due to the high initial adhesion and rapid drying, PVCdesign floor coverings are firmly in place from the start. Adhesive on the floor covering surface can penetrate
fresh and hardened condition without residues being removed. Because of the hard gluing of WAKOL MS 550 PVC and rubber glue, residual impressions are minimized just as well as with a fiber-containing dispersion glue.

Long shelf life due to sealed bucket

WAKOL MS 550 PVC and rubber adhesive is supplied in a practical plastic bucket. An aluminum composite foil, which is welded to the edge of the bucket, provides the best possible protection against moisture and guarantees a storage stability of at least 12 months. Curing in the unopened original bucket and the associated material loss and extra costs are excluded.

Economic

As a 1-component product, the troublesome and cumbersome mixing is avoided when using WAKOL MS 550 PVC and rubber adhesive. This means that you do not need mixer power at the building site, unlike in the past for 2-component PU glue. You are not annoyed by dirty stirring tools or loss of time due to mixing. Mixing errors are also a thing of the past. Waiting times are no longer necessary for this modern product. You do not lose money due to hardened residual quantities, which are unavoidable with 2-component products. After covering the residual amount and closing the bucket, the adhesive can be used for subsequent work. There is therefore hardly any residual waste.

Always respect the technical information before processing

--TECHNICAL INFORMATION--

--TECHNICAL INFORMATION-2-

0 stars based on 0 reviews Add your review


Tisasite.com


Door het gebruiken van onze website, ga je akkoord met het gebruik van cookies (uw privacy blijft gewaarborgd) Manage cookies